B&K Precision 2532B - Manual - Manual (Page 177)

177
Chapter 5 Specifications
• All specifications apply to measurements with a 10X probe To
verify that the oscilloscope meets specifications, the oscilloscope
must first meet the following conditions:
o The oscilloscope must have been operating continuously
for thirty minutes within the specified operating
temperature.
o You must perform the Do Self Cal operation, accessible
through the Utility menu, if the operating temperature
changes by more than 5° C.
o The oscilloscope must be within the factory calibration
interval
• All specifications are guaranteed unless noted “typical.”
Specifications
2530B 2532B
Inputs
Input Coupling
AC, DC, GND
Input Impedance 1
MΩ ± 2% || 16 pf ± 3 pf
Maximum input voltage 400 V (DC+AC PK-PK, 1
MΩ input
impedance, X10), CAT I
5 Vrms; +/-10 V Peak for 1 s pulse, 50
% duty cycle (50
Ω BNC)
Ch to Ch Isolation >100:1 at 10 MHz >100:1 at 20 MHz