Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 14)

14
Before installing your water distiller it is important to find a good location.
Following the points listed below will provide the best location for your water
distiller:
1. The water distiller must be plugged directly into a dedicated 120VAC, 15
Amp wall outlet.
2. The water distiller requires sufficient airflow around it to operate. The air
is used to cool the water distiller condensing coil. Locate the water
distiller in an area that will provide enough room for good air flow. Do not
place the water distiller in an enclosed area like a closet.
3. When using the Automatic Feed Water Line Connection to the water
distiller, locate the water distiller close to a household cold water line (after
a water softener if available).
4. Locate the water distiller where a pail or suitable container can be used
for the impurities drain. Close to a floor drain (sewer) is best especially if
the Automatic Drain Kit is installed.
5. When unpacking the water distiller and options note the sizes and
consider this when picking an installation location.
6. Locate the water distiller away from a bedroom or other area where the
noise of the water distiller may be undesirable.
7. Locate the water distiller close to the kitchen faucet area if the automatic
pump option is being used.
8. Locate the water distiller in an area that is clean and free of dust so the
cooling coils remain clean when the fan is drawing fresh air.
Finding a Good Installation Location