Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 54)

54
Remove all loose pieces from the automatic electric drain kit box and save all
packaging until all the parts are identified and located. If any parts are missing or
if you feel you have been given the wrong part, DO NOT return the automatic
electric drain kit. Contact your dealer for the required parts. They will be pleased
to assist you.
Installation
1. If the water distiller has been used without the PWS Automatic Electric
Drain, turn off the water distiller, drain the boiling tank and wait for the
water distiller to cool off.
2. Disconnect the electrical cord and unscrew the Control Cable plug
counter-clockwise. Turn off the feed water line saddle valve, and
disconnect the feed water line.
3. If the PWS APK-2 Pump Kit is installed on the water distiller, disconnect
the two-pin plug from the Accessory Pump receptacle on the bottom of the
water distiller head.
Drain Tube Removal Diagram
4. Remove the wall stabilizer clamp. Refer to the Drain Tube Removal
Diagram above. Remove the gear clamp and drain hose from the barbed
coupler on the rear of the water distiller head.
5. Remove the water distiller head from the charcoal filter canister and
storage tank by lifting off from the storage tank.
6. Turn your water distiller head upside down.
NOTE: Do not attach the Drain Valve Body (B) to the Motor Assembly (E)
until the valve is installed completely on the water distiller head.
TUBE
TO SEWER
GEAR CLAMP (SHIPPED IN PARTS BOX)
BACK OF THE
DISTILLER
BALL VALVE ASSEMBLY