Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 19)

19
3. Remove the sight gauge with valve from the parts box.
Sight Gauge Installation Diagram
4. Refer to Sight Gauge Installation Diagram above. Remove the plastic
hex jam nut from the threaded body of the valve (leaving washer gasket
on threads).
5. Remove the storage tank lid by holding down on the lid and turning the
black knob counter clockwise while lifting, approximately five turns. Slide
the lid to one side and turn the knob and lid together while tilting. This
should allow the Tee Bar bracket under the lid to come out of the tank
opening. Slide the lid out.
6. Push the gasket tightly up against the valve.
7. Insert the threaded valve end with gasket attached through the hole on
the front of the storage tank.
8. While holding the sight gauge with valve in the storage tank hole with one
hand, insert your other hand with the plastic hex jam nut through the
storage tank lid opening.
9. Place the hex nut onto the threaded end of the valve.
10. Hand tighten the hex nut clockwise onto the valve.
3/8" JAM NUT
#10-24 MACHINE SCREW
STAINLESS STEEL
GASKET
THREADED FAUCET END
SIGHT GAUGE
DRAIN VALVE
VALVE HANDLE
STORAGE TANK
SIGHT GAUGE
SUPPORT