Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 49)

49
6. Screw one ½” FPT x ½” elbow to the inlet side of the pump. Tighten using
a 10” adjustable wrench and position towards the storage tank outlet on
the back of the tank (No thread sealant is required as these fittings seal
with a compression cone).
Bulkhead Stem Plug Removal Diagram
7. See Bulkhead Stem Plug Removal Diagram above. Remove the
locking clip from the 3/8” bulkhead on the back of the storage tank by
pulling on the tab. Remove the 3/8” stem plug from the bulkhead by
pushing the dark grey collet against the bulkhead with the JG tool over the
stem plug and pulling out on the stem plug with the other hand (keep plug
for future use).
8. Insert the 3/8” OD tubing all the way into the bulkhead and replace the
locking clip by pulling out on the tube and sliding in the locking clip. Route
the tubing to the inlet elbow of the pump and cut to this length.
9. Slide a 3/8” Nut/Cone/Ring over the pump end of the 3/8” OD tube and
insert the hose into the pump inlet elbow. Slide the nut to the threads and
tighten using a 10” adjustable wrench. Use caution. Do not over tighten.
10. Screw the second ½” FPT x ½” elbow to the outlet on the pump. Tighten
with a 10” adjustable wrench in a position that will work for routing the
hose to the faucet. Use caution not to over-tighten the elbow onto the
pump.
Faucet and Water Line Installation for PWS APK-2
1. Now you are ready to attach the pantry faucet to the sink. The kitchen
sink is the most desirable location for the faucet as it is close to the
cooking area. To install the faucet you will need to drill a 7/8” hole in the
sink and counter where you want the faucet. Drill a 5/8” hole through the
sub floor of the cupboards and floor to accommodate the water tubing.
LOCKING CLIP
STEM PLUG
COLLET BULKHEAD