Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 22)

22
1. Select a household water line to supply the water distiller with feed water.
Be sure to use a cold water line and pick a suitable location closest to the
water distiller location.
Feed Water Line Installation Diagram
Feed Water Line Connection
TOOLS REQUIRED:
For Feed Water Line Connection
(A) Slotted Screwdriver
(B) Drill with 1/8” drill bit (For
Steel or Brass Water Line)
(C) ½” Open End Wrench or
(D) Pliers
(E) JG Removal Tool (supplied
in Parts Box)
(F) Utility Knife
NOTE: If you have a water softener be sure to connect the water distiller
feed line on the outlet side of the softener as soft water will reduce
cleaning and maintaining of the water distiller. Using a water supply from
the outlet of a hot water heater is not recommended as some of the
internal components of the water distiller are not designed to be used with
water temperatures above normal cold household water supply. Scale and
sediment from hot water tanks can also cause problems by plugging the
water distiller raw water plumbing components.
(A) (C) (D)
1/2
" OR
(B) (E) (F)
1/4" WATER FEEDLINE
ELBOW
COLLET
LOCKING CLIP
BOLTS SADDLE VALVE
COMPRESSION
NUT
INSERT
FERRULE
RUBBER
SEAL
LOWER CLAMP
NUTS
COPPER TUBE-NO DRILLING
*STEEL TUBE-DRILL 1/8"Ø
*BRASS TUBE-DRILL 1/8"Ø
*SHUT OFF WATER SUPPLY
WATER SUPPLY TUBE