Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 30)

30
1. Ensure the boiling and storage tank lids are in place and tight.
2. Make sure all control switches are turned off. (See Operation-Controls
Section if not sure how to operate).
3. Ensure the water supply saddle valve is turned fully on by turning counter-
clockwise from tight.
Boiling Tank Water Gauge Pin
Diagram
4. Plug Water distiller into a wall outlet.
5. Turn Power, Fan and Water switches ON (Do not turn Water switch on if
filling manually).
6. Water should be entering the boiling tank. Remove the boiling tank lid to
check. Replace lid if water is entering. The fan and heater should turn on
as soon as the water level is above the heating element.
7. Check for leaks around the saddle valve and supply pipe and around the
water solenoid on the water distiller head. See Water Solenoid Valve in
Water Distiller Head Diagram below.
Water Solenoid Valve in Water Distiller Head Diagram
8. If there are no leaks and the water distiller is operating as described
above, shut all control switches off and perform steam sterilization on the
water distiller head, filter canister and storage tank as described in the
Maintenance and Cleaning section.
NOTE: Manual Fill Operation (If a
pressurized water supply is not
available such as using the water
distiller at a cottage or on vacation) –
Fill the boiler tank by removing the
boiler tank lid and pouring water into
boiler tank up to bottom of the water
level pin. Refer to Boiling Tank
Water Gauge Pin Diagram.
Before Initial Water Distiller Operation
WATER
GAUGE
PIN
DRAIN STRAINER ATTACHED
TO THE DRAIN HOLE
WATER LEVEL
INSIDE BOILER
DRAIN
STRAINER
IMPURITIES
DRAIN OUTLET
SOLENOID VALVE
(HIDDEN)
LOCKING
CLIP
SADDLE VALVE
COLD WATER
SUPPLY LINE
WATER FEEDLINE
ELBOW
COLLET