Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 29)

29
Overheat Reset Switch – Manual Reset
Fuse – 1 Amp Slow Blow 240V
Storage Tank Drain Valve
- Recessed into the front of the water distiller head front
cover.
- The reset button will shut the unit off if the water
distiller has overheated, it may be reset once the water
distiller has cooled off. If the situation continually
repeats itself this may also indicate a problem and
should be looked at by a service center.
- The reset button is a safety feature and is designed to
shut the water distiller down should it overheat.
- Push your finger through the hole in the front cover
labelled ‘Manual Reset’ to reset. A snap will be heard
when the switch is reset and distilling can resume.
- This is a feature to protect the pump option electrical
circuit and is located on the bottom of the water
distiller head at the rear.
- Always replace with the proper fuse.
To enjoy pure water from your water distiller storage tank
use the storage tank drain valve on the front of the storage
tank. The valve handle can be tipped one way to control
the flow of water or tipped over the opposite direction and
locked in the open position to fill large containers. Water
can be pumped automatically to a faucet at the kitchen sink
or other location by installation of an Optional Pump Kit.
See PWS APK-2 Pump Kit and PWS APK-2 Pump Kit
Installation in the Optional Accessories Section for a
diagram of the kit and installation instructions.
STORAGE TANK
SIGHT GAUGE AND
DRAIN VALVE