Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 45)

45
PROBLEM CAUSE
J) With the Pump Option,
there is no water at the
faucet.
1. Pump plug on the water distiller head is loose.
Check plug at rear of water distiller head.
2. Storage tank is empty. Water distiller has quit.
See A) above.
3. There is no power to the pump. Check to make
sure the pump is plugged into the water distiller
head. Check to make sure there is power at the
wall outlet.
4. Fuse on the water distiller head needs replacing.
5. Pump motor failure. Call Service Center.
6. Kinked water line between the pump and the
faucet. Check water line for kinks.
7. Bottom float in the storage tank is stuck or faulty.
Open water distiller storage tank and check level
sensor. Call Service Center.
K) With Pump Option, pump
starts and stops without
drawing any water
1. Small leak in the water line or faucet. Check
water line for leaks.
2. Loose fittings on pump or lines. Check fittings
for leaks-with proper wrench. See Pump Kit
Installation Section.
3. Check-valve in pump may be stuck open. Call
service center.
L) Water distiller does not
operate and storage tank is
empty.
1. Storage tank level sensor assembly is faulty.
Open storage tank and check level sensor
operation.
2. Storage tank level sensor relay is faulty. Call
Service Center.
3. Control Cable is not connected. Check
connection between water distiller head and
storage tank.
4. Check to make sure there is power at the wall
outlet.
5. Make sure all control switches are on.
(M) Storage tank only fills
2/3 full and will not fill to the
top. 1. Storage tank level sensor is faulty. Top float is
stuck in full position. Open storage tank and check
floats on level sensor. Call Service Center.
(N) Distiller does not seem
to produce as much water as
specified. See Section in Guide: 10 Factors That Will Affect
Your Water Distiller Production.