Hydrotech Precision-PWS 8-5 OWNERS GUIDE User Manual
Page 52
52
Electrical Connections-Rear View Diagram
7.
If the Automatic Electric Drain option is installed on your water distiller,
see the Electrical Connection-Rear View Diagram above. Reconnect
the two-pin plug from the valve motor box into the receptacle labelled
‘Accessory Drain’ on the bottom of the water distiller head. If the
Automatic Electric Drain option is not installed on your distiller, close the
manual drain valve. Plug the electrical cord into the wall outlet.
8.
It is a good idea to fill your storage tank approximately ½ full with distilled
water after you install the pump to check the fittings for leaks. If you do
not have any distilled water available, let the water distiller run.
9.
Once the storage tank is approximately ½ full, connect the two pin plug
from the pump into the receptacle labelled ‘Accessory Pump’ on the
bottom of the water distiller head. The water level switch in the storage
tank will automatically turn the pump switch on as soon as it is plugged in
and the pump will pressurize your water line. When this happens, check
for leaks.
10.
To enjoy water at the pantry faucet, lift the lever. The pump will start and
stop as required to keep distilled water flowing at the faucet.
NOTE: Keep pump unplugged until you are available to check for leaks
upon initial installation
ACCESSORY DRAIN
CONTROL CABLE
REPLACEABLE
FUSE
ACCESSORY
PUMP