Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 4)

4
Introduction
Congratulations on the purchase of the most advanced water distiller in the
industry! When installed and maintained properly, your Precision Water Distiller
will provide years of safe, trouble free service. It is important to observe and
follow the safety and maintenance instructions carefully. If you have any
questions or concerns regarding installation or operation of your water distiller,
please contact your dealer.
All 120 VAC Precision Water Distillers are certified to cCSAus Classes 2831-02
and 2831-82 under the Canadian and American Electrical Code.
All water distillers are factory tested with a high voltage ‘Dielectric Strength Test’
and ground fault test prior to shipping.
Precision Water Distillers have been tested by EnviroTest Laboratories which
found the water distillation units to be very effective water treatment systems
capable of removing both harmful pathogens and toxic chemicals from water. In
their study all pathogens were eliminated and none were found in the distilled
water. The water distillation system also effectively removed all of the soluble
inorganic chemicals tested. Removal efficiencies of 99% or greater were
achieved for almost every chemical tested.
All Precision Water Distillers are operated and tested at the factory and have
produced distilled water to make sure all components are functioning properly.
All water distillers are wiped clean before shipping, but there may be a water ring
inside the boiling tank. There may also be an off-colour line at the seams of the
storage and boiler tank. This is caused by the TIG welding process used during
manufacturing. This is normal and is not a sign of a problem. Follow all the
Before Initial Water Distiller Operation procedures and you will have pure
water in no time.
Your Precision Water Distiller must be installed according to any Local, State or
Provincial Regulations.