Hydrotech Precision-PWS 8-5 OWNERS GUIDE - Manual (Page 48)

48
1. Remove all loose pieces from the pump kit box and save all packaging
until all the parts are identified and located. If any parts are missing or if
you feel you have been given the wrong part, DO NOT return the pump
kit. Contact your dealer for the required parts. They will be pleased to
assist you.
2. Disconnect the electrical cord. Make sure the storage tank is empty.
Pump Wall Mounting Diagram
3. See the Pump Wall Mounting Diagram above. Mount the Pump solid to
a wall location using four #10-12 x 1” screws.
4. Remove any blue caps from the pump inlet and outlet by unscrewing
counter-clockwise (pliers may be required).
5. Remove the Nut, Cone and Ring from the two ½” FPT x ½” elbows by
unthreading counter-clockwise. Keep these in order and available, do not
lose them!
TOOLS REQUIRED:
For PWS APK-2 Pump Kit
Installation
(A) Basin Wrench
(B) #2 Robertson Screwdriver
(C) 10” Adjustable Wrench
(D) 3/8” Drill
(E) 3/8” Nut Driver or
(F) Pliers or
(G) Ratchet with 3/8” socket
(H) Utility Knife
(I) 5/8” Wood Bit (minimum
length of 8”)
(J) 7/8” Hole saw for sink
(K) JG Removal Tool
PWS APK-2 Pump Kit Installation
(E) (F)
OR
OR
(G)
3/8
"
3/8
"
(C)
10
" M
IN
.
(K)
(D)
(H) (I) (J)
(B) (A)
OPTIONAL PUMP KIT