Hach-Lange SC 1000 - Manual (Page 19)

17
Installation
Figure 7 Housing breakouts
1 Storage card slot 6 AC power connection (PS1), strain relief M20 × 1.4 mm
(4–8 mm cable diameter), conduit, different version of
power cord (optional)
2 GSM antenna connection (optional) 7 Network interface
3 Cable assembly for connection to probe module 8 Cable assembly for connection to display module
4 Service port 9 Relay connection—2.19 mm for conduit or strain relief
M20 × 1.5 with union mount (9–13.5 mm cable diameter)
5 Power outlet for 100–240 VAC powered sc probes 10 Configured as either sc probe connectors or
strain-reliefs, M16 × 1.5 (5–6 mm cable diameter)
N o t i c e
Please observe the output voltage at the sockets.
The output voltage supplied by the sc controller to the
sockets corresponds to the country-specific mains voltage to
which the controller is connected.
Never connect consumers with a lower input voltage to the
sc controller if the sc controller is operated with a higher
mains voltage.