2 add probe connections, 3 connect ac powered sc probes, Installation 3.8.2 add probe connections – Hach-Lange SC 1000 User Manual

Page 46

Advertising
background image

44

Installation

3.8.2 Add probe connections

When all probe connectors on the sc1000 controller are already in use for probes, more
probe connectors can be added (max. 8 probe connectors). It may be necessary to
remove an existing expansion card if accessibility to probe connectors is obstructed (refer
to

section 3.6.6, page 37

).

Note: If a probe module has the maximum number of probes, more probes may be added to the
system by purchasing additional probe modules.

To add probe connections:

1. Remove power from the instrument. Open the probe module cover.

2. Remove the fitting or plug from a spare probe socket hole.

3. Screw a new probe connector into the housing and connect the probe connector to a

probe connection on the main circuit board. Any available probe connector can be
used.

4. Assemble the housing.

3.8.3 Connect AC powered sc probes

Note: AC power outlets can only be connected when a 100 V–240 V power supply is fitted in the
sc1000 controller.

Figure 34 Removing the protective cover

1

sc probe connection

2

Protective cover

Advertising