Hach-Lange SC 1000 - Manual (Page 44)

42
Installation
Figure 32 Connecting the network connector to the sc1000 network terminating resistor
1 Shell, bottom 6 Housing, network connector
2 Network connector printed circuit board with shell bottom 7 Seal, cord grip
3 Clamp, network cable(s) 8 Cord grip
4 Screw, pan head 9 Plug, rubber, cord grip 2
5 Cables, network 1 10 Screws, self-tapping (2×)
1 Route cables as shown and make sure that clamp is fastened securely.
2 Use this plug if the cord grip is not used, refer to inset in Figure 32 .