Hach-Lange SC 1000 - Manual (Page 40)

38
Installation
4. Remove the screws securing the card and remove the card.
5. Replace the card and configure the card.
3.7 Install an sc1000 network (sc1000 bus connection)
An sc1000 network connects up to 32 participants ( Figure 28 ). Participants are defined as
anything attached to the network including probes and optional cards but not counting the
display module or probe modules. Only one display module is allowed for one sc1000
network.
Each probe module has an sc1000 network interface ( Figure 29 ). Use the sc1000
network cable and the sc1000 network connector to set up a network. Suitable cable and
network connector is available from the manufacturer.
Figure 28 sc1000 network
1 Profibus/Modbus connection 4 Probe module
2 sc1000 controller (Display and probe module) 5 Probe
3 sc1000 bus connection