Hach-Lange SC 1000 - Manual (Page 98)

96
Advanced Operations
6.3.3.5 Function set to WARNING working mode
Figure 60 Relay behavior—2 POINT Control mode (ON/OFF delay)
1 High Alarm 4 OFF delay (when phase is low)
ON delay (when phase is high)
2 Low Alarm 5 Time (x-axis)
3 ON delay (when phase is low)
OFF delay (when phase is high) 6 Source (y-axis)
Table 33 Color/line code for Figure 60
Selected Source
Relay contact (phase low)
Relay contact (phase high)
WARNING
WARNING LIST
Default value: Disabled
Sets the monitoring of the internal warning bits of the selected source.
ENABLED: Monitoring is active.
DISABLED: Monitoring is not active.
ERROR LIST
Default value: Disabled
Sets the monitoring of the internal error bits of the selected source.
ENABLED: Monitoring is active.
DISABLED: Monitoring is not active.