Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 192)

174
CATC BTT RAINER 2.11 C HAPTER
User’s Manual
Return value
• “Success”
• “Failure”
• “Failed: Device not found”
• “Not connected”
Comments
Enters Hold mode with parameters as specified.
Example
Device = '010203040506';
result = HCIHoldMode(Device, 0xFFFF, 0x50);
Trace("HCIHoldMode result is: ", result, "\n");
HCIMasterLinkKey
HCIMasterLinkKey(KeyFlag)
Return values
Returns a list with three values: status, HCI handle, and key flag.
Status (element 0) is one of the following:
• “Success”
• “Failure”
HCI handle (element 1) is the handle for the ACL connection.
Key flag (element 2) is the key flag (either 0 or 1).
Comments
This command is used to force the master of the piconet to use temporary
or semi-permanent link keys.
Example
result = HCIMasterLinkKey(0);
Trace("Merlin's Wand MasterLinkKey returned:", result[0],
"\n");
if(result[0] == "Success")
{
Trace(" Connection Handle : 0x", result[1], "\n");
Parameter Meaning Default Value Comments
KeyFlag 0x0 use semi-permanent link keys
0x1 use temporary link keys