Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 296)

278
CATC BTT RAINER 2.11 C HAPTER
User’s Manual
HCICatcInquiryScan
HCICatcInquiryScan(TestScenario,Ninquiry)
Return value
• "Success"
• "Failure"
• "Invalid Parameter"
• "Timed out"
Comments
This command supports TCI functionality that requires BtTrainer to enter
modified Inquiry Scan mode, and respond to the IUT Inquiry attempts as
required by the Bluetooth Baseband test cases.
This command turns off the scan enable mode. You should call
Write_Scan_Enable to restore the value.
Used in Test Cases
Example
result = HCICatcInquiryScan(TestScenario,
Ninquiry);Trace(result);
Parameter Meaning Default Value Comments
TestScenario 0x00 -Exit Inquiry Scan test
mode
0x01- Disable responding
to incoming inquiry ID
packets. Perform according
to TP/PHYS/INQ/BV-01-C
or TP/PHYS/INQ/BV-02-C
according to the current
Country Code settings.
0x02-0xFF- Reserved
Ninquiry Number of train repetitions.
Default is 256
Test Case Description
TP/PHYS/INQ/BV-01-C Inquiry hop seq/79 channel. Disable responding to incoming inquiry
ID packets as defined in this test case