Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 299)

281
CATC BTT RAINER 2.11 C HAPTER
User’s Manual
Comments
This command supports TCI functionality that requires BtTrainer to enter
modified Page Scan mode, and respond to the IUT Page attempts as
required by the Bluetooth Baseband test cases
Used in Test Cases
Example
TestScenario = 1;
Npage = 256;
result = HCICatcPageScan(TestScenario,Npage);
Trace(result);
HCICatcTestControlMaster
HCICatcTestControlMaster((Address, TestScenario,
HoppingMode, TxFrequency, RxFrequency, PowerControlMode,
PollPeriod, PacketType, NumberOfPackets, TimeLength,
Data, ErrorType, ErrorMask, TxJitter)
Comment
This command supports TCI functionality that requires BtTrainer to be in
the Test Mode as a master device. It will generate LMP_Test_Control to
enter the Test Mode, if necessary, and will start performing the test, as
specified by the parameters.
Test Case Description
TP/PHYS/PAG/BV-01-C Page hop seq/79 channel. Tester does not respond to the Page
ID packets as defined in this test case.
TP/PHYS/PAG/BV-03-C Page response to 1st msg/79 channel. Tester responds to the
first Page ID and does not respond to the first FHS packet as
defined in this test case.
TP/PHYS/PAG/BV-05-C Page response to 2nd msg/79 channel. Tester does not respond
to the first Page ID and the first FHS packet as defined in this
test case.
Parameter Values Description
Device
2 Bytes
Example: 0x0001 HCI ACL Connection handle