Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 1126)

1096 Fabric OS Command Reference
53-1003131-01
supportShow
2
fcip
FCIP group commands, disabled by default.
ag
Access Gateway group commands, disabled by default.
dce_hsl
DCE group commands, enabled by default.
crypto
Encryption group commands, disabled by default.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
This is a diagnostic command and should only be run for diagnostic support.
Output generated by this command may vary by switch configuration and platform. Output may change
without notice.
OPERANDS
This command has the following operands:
slot
On bladed systems only, specifies a slot number.
port1-port2
Specifies a port or a range of ports for which to display supportShow information.
This operand is optional; if omitted, the command displays information for all
ports. The following values are supported:
• A single port in port1-port1 format, for example, "5/8-8".
• A port range where the beginning and end port are separated by a dash, for
example, "5/8-13".
lines
Specifies the number of lines for the portLogDump output. This parameter is
valid only with the slot/port parameters.
EXAMPLES
To display debugging information for a single port on a Brocade 5300:
switch:admin> supportshow 43
VF
======================
Date:
Sun Dec 6 05:10:13 PST 2009
Time Zone:
America/Los_Angeles
Version:
Kernel: 2.6.14.2
Fabric OS: v6.4.0_main_bld09
Made on: Tue Dec 1 20:04:36 2009
Flash: Wed Dec 2 11:54:49 2009
BootProm: 1.0.15
supportshow groups enabled:
os enabled
exception enabled
port enabled
fabric enabled
services enabled