Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 538)

508 Fabric OS Command Reference
53-1003131-01
ipAddrShow
2
ipAddrShow
Displays IP address information for a switch or control processor (CP).
SYNOPSIS
ipaddrshow
ipaddrshow [-cp cp_number] | -chassis
ipaddrshow -slot slot [-eth0 | -eth1 | -gate]
DESCRIPTION
Use this command to display the IP addresses configured in the system.
The -cp option displays the IP address for a specified CP on modular platforms, or use the command
without arguments to display the IP address on a standalone switch, or the IP addresses for both CPs on
a chassis.
On a standalone switch, the command displays the following information:
• Ethernet IP Address
• Ethernet Subnet mask
• The Gateway IP Address
•
Dynamic Host Control Protocol (DHCP): on or Off
•
IPv6 Autoconfiguration Enabled: Yes or No
• Local IPv6 Addresses
• IPv6 Gateway address
• DHCPv6: on or off
On modular platforms, the command displays the following information:
For the chassis:
•
Ethernet IP Address
•
Ethernet Subnet mask
For each CP:
• Ethernet IP Address
• Ethernet Subnet mask
• Host Name
• Gateway IP Address
If the IPFC network interface is configured for logical switches:
•
IPFC address for Virtual Fabric ID
For each CP:
- Backplane IP address
- IPv6 Autoconfiguration Enabled: Yes or No. If enabled, the command displays:

All local IPv6 Addresses
 Gateway IP addresses for both CPs
Local IPv6 addresses display the following identifiers:
•
IP Address type:
- static - A statically configured IPv6 address.
- stateless - Acquired through stateless autoconfiguration.
• IP Address state: