Hasyncstop – Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 506
476
Fabric OS Command Reference
53-1003131-01
haSyncStop
2
haSyncStop
Disables High Availability state synchronization.
SYNOPSIS
hasyncstop
DESCRIPTION
Use this command to temporarily disable High Availability (HA) synchronization.
After issuing haSyncStop, the switch does not go back to sync start unless you perform one of the
following actions: reboot the active CP, reboot the standby CP, insert a new standby CP (blade), or issue
the haSyncStart command The time it takes for the HA sync to complete depends on the system
configuration. The HA sync timeout is set to 10 minutes.
NOTES
Disabling HA synchronization may cause failover to be disruptive.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
None
EXAMPLES
To disable the HA state synchronizing process:
switch:admin> hasyncstop
SEE ALSO
,