Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 822)

792 Fabric OS Command Reference
53-1003131-01
portCfgShow
2
EX_Port
Displays ON when the port is configured as an EX_Port. Otherwise displays (..) or
OFF. This value is set by the portCfgExPort command.
Mirror Port
Displays ON when Mirror Port is enabled on the port. Displays (..) or OFF when
Mirror Port is disabled. This value is set by the portCfg mirrorport command.
SIM Port
Displays ON when SIM Port is enabled on the port. Displays (..) or OFF when SIM
Port is disabled. This value is set by the flow --control flow_name -simport
command.
FC Fastwrite
Displays ON when FC FastWrite is enabled on the port or (..) or OFF when
disabled. FastWrite is disabled by default. This value is set by the portCfg
fastwrite FC Fastwrite is no longer supported as of Fabric OS v7.0.0.
Rate Limit
Displays ON when ingress rate limit is set on the port or (..) or OFF when the
ingress rate limiting feature is disabled. This value is set by the portCfgQos
--setratelimit command. The default value is OFF.
Credit Recovery
Displays ON when Credit Recovery is enabled on the port. Displays (..) or OFF
when the feature is disabled. This value is set by the portCfgCreditRecovery
command. The credit recovery feature is enabled by default.
Port Auto Disable
Displays On when the Auto Disable feature is enabled on a port. Displays (..) or
OFF when the feature is disabled. This feature causes ports to become disabled
when they encounter an event that would cause them to reinitialize. This feature is
enabled by the portCfgAutoDisable command. The feature is disabled by
default. In the single port view, the configured trigger conditions are displayed
when the feature is disabled. Refer to the example section for an illustration.
F_Port Buffers
Displays the number of configured F_Port buffers. Displays (..) or OFF if no
buffers are configured. The buffer value is set by the portCfgfPortbuffers
command.
E_Port Credits
Displays the number of configured E_Port credits. Displays (..) or OFF if no credits
are configured. The credit value is set by the portCfgEportCredits command.
CSCTL mode
Displays ON if CSCTL mode is enabled on the port. Displays (..) or OFF if the
feature is disabled. This parameter is set with the portCfgQos command.
D_Port mode
Displays ON when the port is configured as a D_Port; otherwise displays (..) or
OFF. Refer to the portCfgDPort command for more information. This parameter
is displayed only on on Condor3-based blades that support D_Port capability.
D_Port over DWDM
Displays ON when dwdm is enabled on that port using the portcfgdport
command. This option is used to set if the link connecting two switches is a
DWDM (Dense Wavelength Division Multiplexing) link. However, it can be set on
normal links also.
Fault Delay
Displays the Fault delay value. Displays 0 if the value is R_A_TOV. This is the
default. Displays 1 if the value is 1.2 seconds. This value is set by the
portCfgFaultDelay command. valid for FC ports only.