Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 224)

194 Fabric OS Command Reference
53-1003131-01
cryptoCfg
2
--sync -encgroup
Manually synchronizes the encryption group database belonging to the group
leader node with the databases of all member nodes that are out of sync. If this
command is invoked when the encryption group databases are in sync, the
command is ignored.
Note: When the encryption group is out of sync and the group leader reboots, the
newly selected group leader pushes its database information to all other
members. The new group leader's database information may be different from
what was set up before the group leader was rebooted.
--sync -securitydb
Distributes the security database from the group leader node to all member
nodes. This operation can resolve problems with master key propagation. The
synchronization occurs every time this command is executed regardless of
whether or not the security database was in sync across all nodes in the
encryption group. This command is valid only on the group leader.
--perfshow
Displays the encryption performance.
slot
Displays the encryption performance for specified slot.
-tx
Displays the transmitter throughput.
-rx
Displays receiver throughput.
-tx -rx
Displays transmitter and receiver throughput.
-t interval
Specifies the time interval,in seconds, between refreshes.
EXAMPLES
To create an encryption group "brocade":
SecurityAdmin:switch> cryptocfg --create -encgroup brocade
Encryption group create status: Operation Succeeded.
To create an encryption group "brocade" on a node that has stale configurations:
SecurityAdmin:switch> cryptocfg --create -encgroup brocade
Warning: There are stale (Container|HA|Tape) cryptodb configurations.
Please confirm to delete them.
ARE YOU SURE (yes, y, no, n): [no] y
Warning: These are the list of crypto configuration \
to be cleaned up:
Inside /etc/fabos/mace (crypto_dek.db.0, crypto_dev.db.0, \
crypto_hac.db.0, crypto_pool.db.0, crypto_wwn.db.0).
ARE YOU SURE (yes, y, no, n): [yes]y
Encryption group create status: Operation Succeeded.
To delete the encryption group "brocade":
SecurityAdmin:switch> cryptocfg --delete -encgroup brocade
Encryption group create status: Operation Succeeded.