Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 741)

Fabric OS Command Reference 711
53-1003131-01
portCfg
2
--oxid-base value
Defines the base value of an entry pool of 256 OXIDs supplied to
emulation-generated exchanges. It should fall outside the range used by
FICON channels and devices to avoid conflicts. The default value is 0x8000
(recommended setting). The range is 0x0000 to 0xF000.
--ficon-debug value
Defines optional debug flags. The default value is 0xF7C80000. This
parameter is primarily for use by technical support personnel.
Optional FCIP circuit arguments for fciptunnel create and modify include the
following.
-a | --admin-status [disable | enable]
Enables or disables the circuit. Admin status is disabled by default. Use -a
--admin-status to enable the feature when you create a circuit. Use -a
|--admin-status 0|1 when you modify a circuit.
-S | --local-ip ipaddress | none
Sets the local IP address to use for the circuit. The none option is supported
only on Brocade switch 7840.
-D | --remote-ip ipaddress | none
Sets the remote IP address to use for the circuit. The none option is
supported only on Brocade switch 7840.
--local-ha-ip ipaddress | none
Sets the local HA IP address to use for the circuit. This argument is
applicable on the Brocade 7840 switch only.
--remote-ha-ip ipaddress | none
Sets the remote HA IP address to use for the circuit. This argument is
applicable on the Brocade 7840 switch only.
-C | --connection-type [0|1|2] | [default | listener | initiator]
Specifies whether the circuit is the listener or the initiator. Values are
0=Default, 1=Listener, and 2=Initiator. You can use either the numeric values
or their string equivalents. String values are not case sensitive. In default
mode, the initiator and listener are automatically chosen based on the lower
and higher-order IP address. This can cause a problem in Network Address
Translation (NAT) environments, if both sides of the circuit have lower-order
addresses. This option is a disruptive modify request that causes the tunnel
to bounce. The command prompts for confirmation with an appropriate
message.
-s | --sack 0|1
Disables (0) or enables (1) selective acknowledgement code (SACK) on the
FCIP circuit. SACK is enabled by default. Use -s | --sack to disable the
feature when you create a circuit. Use -s | --sack 0 | 1 to disable or enable
SACK when you modify a circuit. This operand is supported on the Brocade
switch 7800 and FX8-24 blade only.
-k | --keepalive-timeout timeout
Specifies the keep alive timeout in milliseconds. The valid range is 500 ms to
720000 ms. If the tunnel does not already have FICON Emulation enabled,
circuits created on the tunnel default to 10000 ms (10 seconds) for the FCIP
Trunking keep alive timeout. If FICON emulation is enabled on the FCIP
Tunnel when a circuit is created, the keep alive timeout defaults to 1000 ms
(1 seconds).