Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 104)

92 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
4
For additional SNMP configuration information, see:
• Configuring SNMP Access Control
• Enabling SNMP Traps
• Configuring Specific SNMP Traps
• Configuring SNMP RF Trap Thresholds
Configuring SNMP Access Control
Use the SNMP Access Control screen (as launched from the SNMP Access screen) to specify which
users can read SNMP generated information and, if capable, modify related settings from an
SNMP-capable client.
Use the SNMP Access Control screen's Access Control List (ACL) to limit, by Internet Protocol (IP)
address, who can access the Mobility 7131 Access Point SNMP interface.
NOTE
The ACL applies to both SNMP v3 user definitions and SNMP v1/v2c community definitions on the
Mobility 7131 Access Point SNMP Access screen.
To configure SNMP user access control for the Mobility 7131 Access Point:
1. Select System Configuration - > SNMP Access from the Mobility 7131 Access Point menu tree.
Click on the SNMP Access Control button from within the SNMP Access screen.
2. Configure the SNMP Access Control screen to add the IP addresses of those users receiving
SNMP access.