Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 445)

Brocade Mobility 7131 Access Point Product Reference Guide 433
53-1002517-01
8
Syntax:
NOTE
The access point must complete the reboot process to successfully update the device firmware,
regardless of whether the reboot is conducted uing the GUI or CLI interfaces.
admin(system.fw-update)>
update ftp
For information on updating access point device firmware using the applet (GUI), see Updating
Device Firmware on page 4-109.
Statistics Commands
br7131>admin(stats)
Description:
Displays the Mobility 7131 Access Point statistics submenu. The items available under this
command are:
br7131>admin(stats)>show
Description:
Displays Mobility 7131 Access Point system information.
Syntax:
update <mode><iface> Defines the ftp ot tftp mode used to conduct the firmware update. Specifies whether the update is
executed over the Mobility 7131 Access Point’s WAN, LAN1 or LAN2 interface <iface>.
show Displays Mobility 7131 Access Point WLAN, MU, LAN and WAN statistics.
send-cfg-ap Sends a config file to another access point within the known AP table.
send-cfg-all Sends a config file to all access points within the known AP table.
clear Clears all statistic counters to zero.
flash-all-leds Starts and stops the flashing of all Mobility 7131 Access Point LEDs.
echo Defines the parameters for pinging a designated station.
ping Iniates a ping test.
.. Moves to the parent menu.
/ Goes to the root menu.
save Saves the current configuration to system flash.
quit Quits the CLI.
show wan Displays stats for the Mobility 7131 Access Point WAN port.