Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 247)

Brocade Mobility 7131 Access Point Product Reference Guide 235
53-1002517-01
6
CAUTION
Users cannot define a rogue detection method when one of the access point radios is functioning
as a WIPS sensor. To use one of the radios as a detector, you must disable WIPS sensor mode
first, then set a radio for the desired detection method.
2. Configure the Detection Method field to set the detection method (MU or Mobility 7131 Access
Point) and define the 802.11a/n or 802.11b/g/n radio to conduct the rogue AP search.
RF Scan by MU Select the RF Scan by MU checkbox to enable MUs to scan for potential rogue APs within
the network. Define an interval in the Scan Interval field for associated MUs to beacon in
an attempt to locate a rogue AP. Set the interval to a value sooner than the default if a large
volume of device network traffic is anticipated within the coverage area of the target
Mobility 7131 Access Point. The
Scan Interval field is not available unless the RF Scan by
MU checkbox is selected. Brocade Mobility clients must be associated and have rogue AP
detection enabled.