Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 493)

Brocade Mobility 7131 Access Point Product Reference Guide 481
53-1002517-01
10
Switch Configuration
A RFS4000, RFS6000 or RFS7000 (running firmware version 1.1 or later) requires an explicit
adaptive configuration to adopt an access point (if IPSec is not being used for adoption). The same
licenses currently used for br300 adoption can be used for an AAP.
Disable the switch’s Adopt unconfigured radios automatically option and manually add AAPs
requiring adoption, or leave as default. In default mode, any AAP adoption request is honored until
the current switch license limit is reached.
To disable automatic adoption on the switch:
1. Select Network > Access Port Radios from the switch main menu tree.
2. Select the Configuration tab (should be displayed be default) and click the Global Settings
button.
3. Ensure the Adopt unconfigured radios automatically option is NOT selected.
When disabled, there is no automatic adoption of non-configured radios on the network.
Additionally, default radio settings will NOT be applied to access ports when automatically
adopted.
NOTE
For IPSec deployments, refer to Sample Switch Configuration File for IPSec and Independent WLAN
on page 10-484 and take note of the CLI commands in red and associated comments in green.
Any WLAN configured on the switch becomes an extended WLAN by default for an AAP.
4. Select Network > Wireless LANs from the switch main menu tree.
5. Select the target WLAN you would like to use for AAP support from those displayed and click
the Edit button.