Brocade Mobility 7131 Access Point Product Reference Guide (Supporting software release 4.4.0.0 and later) - Manual (Page 474)

462 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
9
Configuring AP#2
AP#2 can be configured the same as AP#1 with the following exceptions:
• Assign an IP Address to the LAN1 Interface different than that of AP#1
• Assign a higher Mesh STP Priority 50000 to the AP#2 LAN1 Interface.
NOTE
In a typical deployment, each base bridge can be configured for a Mesh STP Priority of 50000. In
this example, different values are used to force AP#1 to be the forwarding link since it's a small mesh
network (of only three APs) with AP within close proximity of one another.
NOTE
Ensure AP#1 and AP#2 use the same channel for each 802.11a/n radio, or the APs will not be able
to “hear” each other over different channels.
Configuring AP#3
To define the configuration for AP#3 (a client bridge connecting to both AP#1 and AP#2
simultaneously):
1. Provide a known IP address for the LAN1 interface.
2. Assign the maximum value (65535) for the Mesh STP Priority.