GW Instek GLC-9000 User Manual - Manual (Page 144)

GLC-9000 User Manual
144
SYStem:BEEPer:T3OUT
Sets or queries the tone sound of the T3 output when the voltage output
is at 110%.
Syntax SYStem:BEEPer:T3OUT {ON|OFF}
Query Syntax SYStem:BEEPer:T3OUT?
Query Return Returns the beeper status (on or off when the T3
output is at 110%).
ON The beeper is set to on when the T3
voltage output is at 110%.
OFF The beeper is set to off when the T3
voltage output is at 110%.
Example SYStem:BEEPer:T3OUT ON
Turn on the beeper when the T3 voltage output is at
110%.
Query Example SYStem:BEEPer:T3OUT?
Return: ON
The beeper is on.
SYStem:CLEar:MEASure
Clears all the saved measurement data.
Note: All the saved values will be deleted after this command is executed.
Syntax SYStem:CLEar:MEASure
Example SYStem:CLEar:MEASure
Clears all the saved measurement data.
SYStem:CLEar:PANel
Clears all the panel settings that are saved.
Note: This command will clear all saved panel settings.
Syntax SYStem:CLEar:PANel
Example SYStem:CLEar:PANel
All the panel contents are cleared after executing the
command.