KROHNE Summit 8800 Vol 2 - Manual (Page 52)

52 www.krohne.com 08/2013 - MA SUMMIT 8800 Vol2 R02 en
SUMMIT 8800 HARDWARE DETAILS 05
5 .1 I/O board Configuration
To configure a board, click on the desired board as it appears in Figure 24. The board is divided
into sections for the different in- and outputs, visible only when hovering over section. Depend-
ing on the section clicked, the specific in- or output is selected. As an example, when clicking on
the analog board in slot 3 section digital in, the digital inputs are selected for configuration:
Figure 25 Board configuration window
The top of the configuration screen shows which board type and what slot position is choosen.
On the left side of the window there are different in- and outputs for configuration with the
selected one highlighted. Of course any other selection can then be made by clicking on the sec-
tion. The different selections will be described in the following paragraphs.
On the right the associated pin numbers on the connector are shown.
The button marked with “< None >” signifies what software variable is associated with the
hardware signal connected. A software variable can be selected from an ID data tree. For each
type of signal the tree will only be populated with appropriate variables to prevent mistakes. For
instance in the case of a frequency input only the “active” and “custom” variables are available.