KROHNE Summit 8800 Vol 2 - Manual (Page 73)

73 www.krohne.com
08/2013 - MA SUMMIT 8800 Vol2 R02 en
SUMMIT 8800 STREAM CONFIGURATION 06
Independent of the previous, the user always has the choice to mix and match units, e.g. on a
display page or report. For that reason, both the metric and the USC units can be set indepen-
dently:
Figure 64 Define output engineering units
So the user can use a total volume in Mm3 and at the same time in MMft3.
The possible selections depend can vary, depending on the metering type selected.
6 .2 Meter selection
6 .2 .1 Pulse based meters: Turbine / PD
Liquid Gas Steam
This selection can be used for any meter with one or two pulse outputs.
For liquid the pulses can either be API 5.5 level A or level B to E, for gas API 5.5 Level B to E
only.
• API 5.5 Level B to E : for single or dual pulse with the same of different frequencies and
pulse monitoring.
• API 5.5 Level A: for dual pulse with pulse correction.
See also chapter 3.1.