West Control Solutions ProVU 4 - Manual (Page 18)

ProVU4 Controller, Profiler & Recorder/Controller - Product Manual
59407, Issue 1 – March 2008 Field Upgrade Options Page 17
3 -Field Upgrade Options
Options Modules and Functions
The available plug-in modules, options and accessories are shown in below:
Table 1. Options & Accessories
PART
NUMBER
DESCRIPTION
BOARD
IDENTIFICATION
NUMBER
OPTION SLOT 1
PO1-R10 Single Relay Output for option slot 1 716/01
PO1-S20 Single SSR Driver Output for option slot 1 716/02
PO1-T80 Triac Output for option slot 1 716/03
PO1-C21 Linear mA / Voltage Output module for option slot 1 639/01
OPTION SLOT 2 or 3
PO2-R10 Single Relay Output for option slot 2 or 3 717/01
PO2-W09 Dual Relay Output for option slot 2 or 3 644/01
PO2-S20 Single SSR Driver Output for option slot 2 or 3 717/02
PO2-S22 Dual SSR Driver Output for option slot 2 or 3 644/02
PO2-T80 Triac module Output for slot 2 or 3 647/01
PO2-C21 Linear mA / Voltage Output for option slot 2 or 3 640/01
PO2-W08 24VDC Transmitter Power Supply for option slot 2 or 3 642/01
OPTION SLOT A
PA1-W03 Digital Input for option slot A 641/02
PA1-W04 Basic Auxiliary Input for option slot A 653/01
PA1-W06 RS485 Serial Communications for option slot A 680/01
PA1-ETH Ethernet Communications for option slot A 707/01
OPTION SLOT B
PB1-W0R Full Auxiliary Input (inc digital input B) for option slot B 641/01
OPTION SLOT 4
PO4-R10 4-Relay Output for option slot 4 703/01
ACCESSORIES
PS1-PRF Profiler Enable Key-code
PS1-PRW PC Configuration Software & Lead
Note:
Modules can be either pre-installed at the time of manufacture, or retrofitted in the field.
CAUTION:
Plastic pegs prevent fitting of older non-reinforced single relay modules (Board
Identification Numbers 637/01 and 638/01). Fitting the older relay modules reduces
the isolation rating to Basic 240V Isolation and is therefore not recommended.
Remove this peg when fitting Dual Relay Modules.
Note:
All dual relay modules have reinforced isolation.