West Control Solutions ProVU 4 - Manual (Page 46)

ProVU4 Controller, Profiler & Recorder/Controller - Product Manual
59407, Issue 1 – March 2008 Configuration & Use Page 45
Main Menu
This menu is used to access the various features and configuration menus available in the
instrument. The available menus are dependent upon the features and options fitted and the
way in which it has been configured
Entry into the Main Menu
Holding down

and pressing

from Operation Mode and most other screens will
cause the unit to enter the Main. Each time this key press sequence is made, the
instrument moves to the next menu level above. Sub-menu levels will require this
sequence to be pressed more than once in order to reach the main menu.
Navigating the Main Menu
Once in the Main Menu, press

or

to select the required option
Press

to enter the chosen menu.
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
Unlock Codes
To prevent unauthorised entry, most modes require a pass-code (1 to 9999) to gain entry.
These modes are indicated by the symbol  against their names. The default unlock code
for all modes is 10 and the current codes can be viewed and changed from the Lock Code
View in Configuration Mode. For security, users should to change the codes. If the
Configuration Mode lock code is lost, refer to the Lock code View section of this manual.
Table 5. Main Menu Screens
Main Menu:
Operation Mode Display of the process and setpoint values, selection/adjustment of
the Setpoints, auto/manual control, alarm/event status, trend view and
where available, data recorder and profile information.
Setup Wizard Easy, step-by-step parameter setup for simple applications.
Supervisor Mode If configured from the PC software, a sub-set of up to 50 Configuration
screens can be accessed.
Configuration Menu Accesses the sub-menus for Input; Control; Outputs; Alarms;
Communications; Recorder; Clock; Display; Lock Codes and Reset
To Defaults menus and functions.
Automatic Tuning Selection of Pre-Tune, Self-Tune and Auto Pre-Tune.
Profile Setup Menu Setting of Global Control Parameters for all profiles; Profile creation,
editing and deletion.
Profile Control Menu Selection of profiles. Running, holding or aborting of profiles.
USB Menu Uploading/downloading instrument configuration, profile information
and data recordings.
Recorder Menu Manually starting, stopping and deleting recordings.
Product Information Instrument information, including features and options installed.
Service Information Contact information for service/support etc.