HP Designjet T3500 Production eMFP - Manual (Page 213)

1. Try using higher print-quality settings (see Printing on page 71 ). For instance, if you have set the Print
Quality slider to Speed, try setting it to Quality.
2. Try using thicker paper, choosing from the recommended paper types such as HP Heavyweight Coated
Paper and HP Super Heavyweight Paper. See
Order paper on page 174 .
White spots on the print
You may notice white spots on the print. This is probably due to paper fibers, dust or loose coating material.
To avoid this problem:
1. Try cleaning the paper manually with a brush before printing, to remove any loose fibers or particles.
2. Always keep the cover of your printer closed.
3. Protect your paper rolls and sheets by storing them in bags or boxes.
Colors are inaccurate
If the colors of your print do not match your expectations, try the following:
1. Check that the paper type you have loaded corresponds to the paper type selected in the front panel
and in your software. See View information about the paper on page 65 . Also, press , then Image-
quality maintenance > Calibration status to check the color calibration status. If the status is PENDING
or OBSOLETE, you should perform color calibration: see
Color calibration on page 104 . If you have made
any changes, you may wish to reprint your job in case the problem has been solved.
2. Check that you are printing on the correct side of the paper.
3. Check that you are using appropriate print-quality settings (see Printing on page 71 ). If you have
selected the Speed or Fast options, you may not get the most accurate colors. If you change the print-
quality settings, you may wish to reprint your job at this point in case the problem has been solved.
4. If you are using Application Color Management, check that the color profile you are using corresponds
to the selected paper type and print-quality settings. If you have doubts about which color settings to
use, see
Color management on page 103 .
5. If the problem consists of color differences between your print and your monitor, please follow the
instructions in the “How to calibrate your monitor” section of the HP Color Center. At this point, you may
wish to reprint your job in case the problem has been solved.
ENWW White spots on the print 203