HP Designjet T3500 Production eMFP - Manual (Page 59)

● Default gateway: Specify the IP address of a router or computer that is used to connect to other
networks or sub-networks. If none exist, use the IP address of the computer or the IP address of the
printer.
● Domain name: Specify the name of the DNS domain in which the printer resides (for example,
support.hp.com).
NOTE: The domain name does not include the host name: it is not the fully qualified domain name,
such as printer1.support.hp.com.
● Idle timeout: Specify the time that an idle connection is allowed to remain open when a remote
computer is waiting for the printer. The default value is 280 seconds. If set to zero, the timeout is
disabled and the connection is allowed to remain open indefinitely.
● Default IP: Specify the IP address to use when the printer is unable to obtain an IP address from the
network when powered on or when reconfigured to use BOOTP or DHCP.
● Send DHCP requests: Specify whether DHCP requests are transmitted when a legacy default IP address
or a default Auto IP is assigned.
To configure the same network settings from the front panel, press , then Connectivity > Network
connectivity > Gigabit Ethernet > Modify configuration.
You have various other options available from the Connectivity > Network connectivity > Advanced menu.
● Allow SNMP: Specify whether SNMP is permitted.
● Embedded Web Server > Allow EWS: Specify whether the Embedded Web Server is enabled.
● Web Services > Printer utility software: Enable or disable the HP Utility.
● Web Services > Color and paper management: View the color and paper management settings.
● Web Services > Scanner SDK.
● Restore factory settings: restore the initial default values of the network settings.
Change the graphic language setting
You can change the graphic language setting by launching the Embedded Web Server from the HP Utility with
the following steps.
1. Under Windows, select the Admin tab, then Printer settings > Printing preferences.
Under Mac OS X, select Printer settings > Printing preferences.
2. Select one of the following options.
● Select Automatic to let the printer determine which type of file it is receiving. This is the default
setting; it works for most software applications. You should not normally need to change it.
● Select HP-GL/2 only if you are sending a file of that type directly to the printer, without going
through a printer driver.
● Select PDF only if you are sending a file of that type directly to the printer, without going through a
printer driver (PostScript printers only).
ENWW Change the graphic language setting 49