HP ProLiant DL760 Server - Manual (Page 49)

Installing the Server in a Rack 2-15
Compaq Confidential – Need to Know Required
Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:
Part Number: 173774-001 File Name: c-ch2 Installing the Server in a Rack.doc Last Saved On: 1/24/01 4:46 PM
Rack Warnings and Precautions
Before beginning these procedures, make sure you understand the following
warnings:
42 - 62 kg
93 - 137 lb
WARNING: To reduce the risk of personal injury or damage to the
equipment:
■ Observe local occupational health and safety requirements and
guidelines for manual material handling.
■ Obtain adequate assistance to lift and stabilize the chassis
during installation or removal. The product will be unstable
when not fastened to the rails.
■ Remove all hot-plug power supplies and drives to reduce the
overall weight of the product.
WARNING: To reduce the risk of personal injury or damage to the equipment,
be sure that:
■ The leveling jacks are extended to the floor.
■ The full weight of the rack rests on the leveling jacks.
■ The stabilizing feet are attached to the rack if it is a single rack installation.
■ The racks are coupled together in multiple rack installations.
■ Only one component is extended at a time. A rack may become unstable if
more than one component is extended for any reason.
IMPORTANT: To reduce the overall weight of the system, Compaq recommends that all
power supplies, hot-plug hard drives, and top access panel be removed from the server
before loading it onto the rails.
IMPORTANT: Refer to the following rack documentation for further cautions:
■ 9000 Rack Series Products Audio-Visual (AV) CD Kit (shipped with Compaq racks)*
■ Rack Builder Pro Configuration Tool CD (available on the Compaq website or can be
ordered with the Rack Resource CD Kit)
■ Rack Products Documentation CD (available on the Compaq website or can be
ordered with the Rack Resource CD Kit)
* The Rack 7000/4000 Series Rack Resource CD Kit ships with all Compaq 7000 and
4000 Series Racks.