Adding non-hot-plug expansion boards, Adding non-hot plug expansion boards -20 – HP ProLiant DL760 Server User Manual
Page 94
4-20 Compaq ProLiant DL760 Servers User Guide
Compaq Confidential – Need to Know Required
Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:
Part Number: 173774-001 File Name: e-ch4 Installing Hardware Options - Server Power Off.doc Last Saved On: 1/25/01 9:33 AM
Adding Non-Hot-Plug Expansion Boards
You can use non-hot-plug expansion boards in the ProLiant DL760 server, but
you must install them according to the following procedure. Prepare the server
by performing the following:
1. Back up your server data.
2. Shut down the operating system as directed in your operating system
instructions.
3. Power down the server.
4. Slide the I/O module out and open the top access panel.
To add an expansion board:
1. Open the top access panel.
2. Press on the top of the appropriate expansion slot release lever
and
open the lever toward the rear of the expansion slot
.
3. Remove the expansion slot cover
.
4. Open the air baffle
.
1
3
4
2
Figure 4-16. Preparing the hot-plug expansion slot for installation