HP ProLiant DL760 Server - Manual (Page 95)

Installing Hardware Options - Server Power Off 4-21
Compaq Confidential – Need to Know Required
Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:
Part Number: 173774-001 File Name: e-ch4 Installing Hardware Options - Server Power Off.doc Last Saved On: 1/25/01 9:33 AM
5. Insert the expansion board into the appropriate expansion slot

,
pushing firmly until the board is securely seated.
6. Close the air baffle
.
7. Close the expansion slot release lever from the rear of the unit to secure
the board . Make sure that the lever latches into the closed position.
3
1
2
Figure 4-17. Inserting an expansion board
8. Connect the expansion board I/O cable as appropriate.
9. To keep the full-length expansion boards fully seated, be sure the
L-shaped slot keeper tabs on the plastic expansion board guide are
positioned over the forward end of the expansion board. Using the slot
keepers is especially important when expansion boards are added or the
server is moved.
10. Close the top access panel and slide the I/O module into the server.
11. Power up the server.
12. Run the ROM-Based Setup Utility, as described in Chapter 8,
“Configuring the Server.”
NOTE: See the Compaq QuickSpecs for the Compaq ProLiant DL760 servers at
www.compaq.com for a list of supported I/O expansion boards.