HP LaserJet M4345 Multifunction Printer series - Manual (Page 53)

Menu item Sub-menu item Sub-menu item Values Description
Fax Send Settings Fax Dial Volume Off
Medium (default)
High
Use this feature to set the volume of the
tones that you hear while the device dials
the fax number.
Error Correction
Mode Enabled (default)
Disabled
When Error Correction Mode is enabled
and an error occurs during fax
transmission, the device sends or receives
the error portion again.
JBIG Compression Disabled
Enabled (default)
The JBIG Compression reduces fax-
transmission time, which can result in lower
phone charges. However, using JBIG
Compression sometimes causes
compatibility problems with older fax
machines. If this occurs, turn off the JBIG
Compression.
Maximum Baud Rate Select a value from
the list. Use this feature to set the maximum baud
rate for receiving faxes. This can be used
as a diagnostic tool for troubleshooting fax
problems.
Dialing Mode Tone (default)
Pulse
Select whether the device should use tone
or pulse dialing.
Redial On Busy The range is
between 0 and 9.
The factory default
is 3 times. Type the number of times the device should
attempt to redial if the line is busy.
Redial On No
Answer Never (default)
Once
Twice
Use this feature to specify the number of
times the device should attempt to dial if
the recipient fax number does not answer.
NOTE Twice is available in
locations other than the United
States and Canada.
Redial Interval The range is
between 1 and 5
minutes. The factory
default is 5 minutes. Use this feature to specify the number of
minutes between dialing attempts if the
recipient number is busy or not answering.
Detect Dial Tone Enabled
Disabled (default)
Use this feature to specify whether the
device should check for a dial tone before
sending a fax.
Dialing Prefix Off (default)
Custom
Use this feature to specify a prefix number
that must be dialed when sending faxes
from the device.
Billing Codes Off (default)
Custom
When billing codes are enabled, a prompt
appears that asks the user to enter the
billing code for an outgoing fax.
Minimum Length The range is between 1 and 16 digits. The default is 1 digit.
Table 2-11 Fax Setup menu (continued)
ENWW Initial Setup menu 41