HP LaserJet M4345 Multifunction Printer series - Manual (Page 99)

For tray2 and the optional 500-sheet trays, load paper with the front side facing down, and the top,
short edge toward the right.
Load small sizes, custom sizes, or heavy paper
Custom-size paper can be printed from tray1, tray2, or an optional 500-sheet tray.
NOTE The MFP might print at a slower speed when printing on small sizes, custom sizes,
and heavy paper. For more information about paper that has a special finish, such as laid or
bond paper, see
Load paper that has a special finish .
Weight and sizes
See the following table for specifications when printing on custom or heavy paper.
Tray Minimum size Maximum size Supported weights
Tray1 76x 127mm (3x5inches) 216x356mm (8.5x14inches) 60to200g/m 2 (16to53lb)
Tray2 and optional 500-
sheet tray 148x210mm (5.8x8.2inches) 216x356mm (8.5x14inches) 60to120g/m 2 (16to32lb)
Guidelines for heavy paper
To help prevent toner from rubbing off of the paper, some heavier paper types should be printed
using a higher fuser mode. At the control panel, scroll to and touch
Administration , touch Print
Quality , and touch Fuser Modes .Touch the paper type that you are using. Set the fuser mode to
High1 or High2 . Using these modes helps prevent toner from rubbing off the page, but using them
might slow the device speed or create other problems, such as increased curl.
ENWW Load media 87