HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 111)

HP EFS WAN A CCELERATOR M ANAGER U SER ’ S G UIDE 111
5 - M
AN
AGING
HP EFS
W
A
N
A
C
C
EL
ER
ATO
R
M
ANA
GER
To configure static
network routes 1. Click the Setup Manager tab to expand the Setup Manager menu.
2. Click Routing to display the Networking - Routing page.
Figure 5-3. Setup Manager: Networking - Routing Page
3. Use the controls to complete the configuration, as described in the following table.
4. To save the settings permanently, click Save.
To revert to the running configuration, click Reset.
Setting the
Domain Name
Service
You modify your initial DNS settings or add secondary and tertiary DNS name servers
in the Networking - DNS Settings page.
During the initial setup of the HP EFS WAN Accelerator Manager you specified the
primary Domain Name Service (DNS) server and domain for the system. Modify your
settings in the DNS Settings page.
NOTE: HP recommends you use DNS.
Control Description
Add New Route Destination. Type the IP address in the text box.
Netmask. Type the subnet mask in the text box.
Gateway. Type the IP address for the gateway in the text box. The gateway must be in the
same network as the primary or auxiliary interface.
Add Route. Click this button to add the entry to the list.
Remove Selected Routes. Click the check box next to the entry and click Remove
Selected Routes to remove the entry from the list.