HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 22)

22 2 - I NSTALLING AND C ONFIGURING THE HP EFS WAN A CCELERATOR M ANAGER
‹ One rail kit
‹ HP StorageWorks EFS WAN Accelerator Documentation Set CD-ROM
If any items are damaged or missing, go to http://www.hp.com/support for
replacement or repair.
Preparing Your Site for Installation
This section lists the prerequisites to installation.
Ensure your site meets the following requirements:
‹ A standard electronic environment where the ambient temperature between 10 º C
and 35 º C (50 º F and 95 º F ) and the relative humidity is between 10% and 90%
(non-condensing). For detailed information, see Appendix B, “HP EFS WAN
Accelerator Manager Specifications.”
‹ An Ethernet connection available within the standard Ethernet limit.
‹ Space on a two- or four-post, 19-inch mounting rack.
‹ A clean power source dedicated to computer devices and other electronic devices.
The HP EFS WAN Accelerator Manager is completely assembled with all the
equipment parts in place and securely fastened. The HP EFS WAN Accelerator
Manager is ready for installation with no further assembly required. You might need
an appropriate screwdriver if mounting the HP EFS WAN Accelerator Manager into a
threaded-hole rack. Refer to the instructions that came with the rack mount kit. Also
refer to the documentation that came with your system for important rack planning
resource instructions.
Completing the Configuration Checklist
This section lists the parameters you specify to complete the initial configuration of the
HP EFS WAN Accelerator Manager and to register remote HP EFS WAN
Accelerators.
Be prepared to provide values for the parameters listed in the following checklist.
Appliance Parameter Your Value