HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 124)

124 5 - M ANAGING HP EFS WAN A CCELERATOR M ANAGER S ETTINGS
To set an NTP server 1. Click the Setup Manager tab to expand the Setup Manager menu.
2. Click Date & Time in the left menu to expand the Date & Time menu.
3. Click the NTP Servers tab to display the Date & Time - NTP Servers page.
Figure 5-14. Setup Manager: Date & Time - NTP Servers Page
4. Use the controls to complete the configuration, as described in the following table.
5. To save the settings permanently, click Save.
To revert to the running configuration, click Reset.
Managing Accounts on the HP EFS WAN
Accelerator Manager
This section describes how to set administrator access to the HP EFS WAN Accelerator
Manager. By default, the authentication method is local, the administrator user name
is admin, and the password is the password you set during initial configuration.
Control Description
Add New NTP Server Server IP. Type the IP address for the NTP server in the text box.
Version. Select the NTP protocol version number from the drop-down list.
Enabled. Select True to enable synchronization; select False to disable.
Add Server. Click Add Server to add the NTP server to the list.
Enable To enable a NTP server that has been added to the list, click the check box and click
Enable.
Disable To disable a NTP server that has been added to the list, click the check box and click
Disable.
Remove Selected Servers To remove an NTP server from the list, click the check box next to the entry and click
Remove Selected Servers.