HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 115)

HP EFS WAN A CCELERATOR M ANAGER U SER ’ S G UIDE 115
5 - M
AN
AGING
HP EFS
W
A
N
A
C
C
EL
ER
ATO
R
M
ANA
GER
3. Use the controls to set alarms for a profile, as described in the following table.
4. Click Apply to apply the setting to the running configuration.
When you apply page settings, the values are applied to the running configuration
but not saved permanently. The Save Configuration icon displays a flashing
orange arrow to remind you to save your configuration.
5. To save the settings permanently, click Save.
To revert to the running configuration, click Reset.
Setting Email
Notification
You set email notification parameters for HP EFS WAN Accelerator Manager events
and failures in the Reports - Notification page.
By default no email addresses are specified for HP EFS WAN Accelerator Manager
event and failure notification.
Control Description
CPU Alarms Raise Alarm When CPU Utilization Reaches. Check this box to trigger an alarm if the
average and peak threshold for the Central Processing Unit (CPU) utilization is
exceeded. When an alarm reaches the rising threshold, it is activated; when it reaches the
lowest or reset threshold, it is reset. After an alarm is triggered, it is not triggered again
until it has fallen below the reset threshold.
This alarm is enabled by default, with a rising threshold of 90% and a reset threshold of
70%.
Rising Threshold. Type a whole number to specify a percent of CPU utilization.
Reset Threshold. Type a whole number to specify a percent of CPU utilization.
Memory Paging Alarm Raise Alarm When Extended Memory Paging Activity is Detected. Check this box to
trigger the memory paging alarm. If 100 pages are swapped every couple of hours, the
appliance is functioning properly. If thousands of pages are swapped every few minutes,
contact HP technical support.
This alarm is enabled by default.