Wiring using the screw terminals, Figure 24, Screw terminal block – Vaisala WXT520 User Manual
Page 50
User’s Guide ______________________________________________________________________
48 __________________________________________________________________ M210906EN-C
Wiring Using the Screw Terminals
1.
Loosen the three long screws at the bottom of WXT520.
2.
Pull out the bottom part of the transmitter.
3.
Insert the power supply wires and signal wires through the cable
gland(s) in the bottom of the transmitter. Cable glands are included
in the optional Bushing and Grounding Kit (order code 222109).
4.
Connect the wires according to
.
5.
Replace the bottom part and tighten the three screws. To make sure
that the radiation shield stays straight, do not tighten the screws all
the way in one go. Do not overtighten.
0803-035
Figure 24
Screw Terminal Block
The following numbers refer to
:
1
=
Screw terminals