Red Lion IndustrialPr 6000 Router - Manual (Page 100)

Software User Guide 100
Services Tab
• Custom: Configured special actions are applied:
• Block All: In addition to the actions taken in Block Network, all access to the device including via physical ports (console,
etc.) is blocked.
• Block Network: All network traffic, except to a SixView Manager server, will be blocked.
• Report Only: The device reports violation events to a SixView Manager server.
Configure Advanced GPS Parameters: Select Yes to configure advanced GPS parameters.
Valid Points Required (Required): The maximum number of valid GPS location entries required for GeoFence bound‐
ary establishment may be entered in this field. The recommended setting for this field is 200.
This configures the number of GPS Data points to collect before building the GeoFence boundary. These points are col‐
lected when instructed to go into initial Lockdown mode. Larger values require more time to build the initial fence, yet
may yield a more accurate Calculated Minimum Radius. The allowable range is 100‐1000.
Distance Reporting Threshold (Required): The value for the Distance Reporting Threshold may be entered in this field.
When not in GeoFence Lockdown, a Distance Threshold exceeded message will be sent to a SixView Manager server
every time the unit is moved more than the configured amount (in feet) from its previously recorded location. This is
typically only useful in a mobile application. The allowable range is 200‐1000000 (feet).
Require User Cleared Violations: Select whether the user is required to clear perimeter violations using the drop‐
down list provided. The recommended setting for this field is 0. Available values are:
• No
• Yes
Whenever a full violation state has been reached (Violation Outside or Violation No Data), the next good GPS data
point received will automatically clear the violation and return the unit to “Lockdown Good”. When this option is set
to Yes, then the Violation will NOT be cleared until a SixView Manager server or user sends down a command to re‐ini‐
tiate Lockdown. This will build a new GeoFence boundary based on current location and radius parameters.
Maximum log entries (Required): The value for Maximum log size may be entered in this field. The recommended
value for this field is 600.
Number of log entries to keep in a GPS raw log in NMEA format. Raw GPS Log access is available upon request. A new
log entry will be generated according to the setting in Raw Log Interval. A maximum of 50k is saved. The allowable
range is 100‐1000.
Discardable # outlier points (Required): The value of the # Outlier Points to Ignore may be entered in this field. The
recommended setting for this field is 5.
When a GeoFence is being established, the GPS engine ignores a certain number of the first few anomalous location
fixes before points outside the GeoFence are subject to violation actions. After that initial ‘settling period’, each new
GPS point must be examined in relation to the established boundary. Even under ideal conditions, intermittent signal
reception and/or multipath interferences issues can result in points being erroneously reported beyond the GeoFence
boundary. This parameter can be used to tune the filtering of this ‘jitter’ to reduce the likelihood of a false positive
GeoFence violation. The allowable range is 0‐50.
Log Update Interval (seconds): This parameter determines how often (in seconds) the current GPS data point will be
saved in NMEA format in a Raw GPS logfile. The allowable range is 5‐10000.
• Click SAVE to store the settings for the next reboot, or click APPLY for the settings to take effect immediately.
Selecting Revert, will reset all fields to factory defaults.