Red Lion IndustrialPr 6000 Router - Manual (Page 127)

Software User Guide 127
Automation Tab
Enable Unsolicited Responses: Select if the DNP Slave should send unsolicited messages to the DNP Master. If this
selection is checked, then the user should also configure the following:
DNP Address to Send Unsolicited Messages to: The address of the station to which DNP Slave will send unsolicited mes‐
sages in the DNP Address to Send Unsolicited Messages field.
Event Report Queue Timeout (ms): The amount of time in milliseconds any event will be allowed to remain in the event
queue before being reported in the Event Report Queue Timeout field. Minimum value: 1,000 ms (1 second), maximum
value: 3,600,000 ms (1 hour).
Event Report Queue Threshold (events): The minimum number of events in the event queue required to trigger the gen‐
eration of an unsolicited even report message in the Event Report Queue Threshold field.
Max. number of events to send in an unsolicited response: The maximum number of events to send in every unsolicited
message.
Note: When planning on using unsolicited responses, there must be at least one DNP object configured to generate
events on any of the three DNP event classes, or else, no events will be generated and thus no unsolicited responses at all
will be generated by the station.
Enable Auto Detection Rate: Check this box to automatically set the detection rate.
Enable Max. time events in queue after disconnect (TCP Server only): Click to enable.
Enable Real Time Data Trace: The DNP V3.00 Slave Driver can be configured to generate real time traces of every Mas‐
ter‐Slave DNP V3.00 transaction for diagnosis and debugging purposes. The real time communication data traces can
be enabled/disabled at any time from the DNP configuration Add‐On and its ASCII output can be redirected either to a
text file within the file system for later upload, to a dumb terminal attached to an unassigned serial port of the station,
or even to a remote Telnet terminal session over the TCP/IP network by entering the corresponding /dev/ttyp (/dev/
ttyp0 to /dev/ttyp3) telnet device.
Time Synchronization: The station can be configured to request Time Synchronization from the DNP V3.00 Master.
Requests can be configured to be made at intervals of once per minute, once per hour, once per day or never.
• Click on the “Save” button to save your configuration. The “Apply” button will save your settings and apply them
immediately. To revert to the previous defaults, click on the “Revert” button.
(Navigation buttons across the bottom of the DNP3 screen match the selections made from the drop down tab menu.)